Cautions

While we take care to make our products as safe as possible, use of any Flux products is at your own risk. Please play safe and listen to your body. See our general tips for safe play here.

Never use the accessory attachment points for suspension or body weight. Our belts are strong but are not rated for these loads. Additionally, the shape of a chastity belt means it is not a safe way to support a suspended person's weight.

Our belts contain enough metal parts to set off metal detectors! We are not responsible for any embarrassment or other consequences from attempting to wear a chastity belt through a security checkpoint.

Never wear your chastity belt during an MRI.

Assembly And Adjustment

1. Thread the rear cable fitting into the adjustment hub. Thread on 20 complete turns to adjust the belt to your as measured size. This fitted can be threaded in or out by up to 10 complete turns to fine-tune rear cable length to suit preferences or changes in body size and shape.
2. Slide the left and right waistband sections into the adjustment hub as shown. These will be a snug sliding fit, but should not need to be forced. If significant force is needed to insert them, you may have the left and right sides reversed.
3. Align the threaded holes in the waistband sections with the holes in the adjustment hub and tighten the four M4x8mm screws using the TX20 torx bit. For an as measured fit, there will be one threaded hole showing past the adjustment hub on each side. The waistband sections can be moved in or out to other notches to suit preferences or changes in body size and shape. We recommend having both waistband sections adjusted to the same notch to maintain symmetry of the rear cable. Each side of the waistband should be secured using two screws. Do not over extend the waistband such that it can only be secured with a single screw.
4. (Optional) Attach the side D-Rings using two M6x8mm screws.
5. (Recommended) Apply a moisturizer or skin protectant.
6. Insert the puzzle piece ends of the waistband into their corresponding slots on the shield.
7. Insert the keys into the locks and turn so the tailpiece is aligned with the pin bible as shown. Insert the locks into the lock-holes on the underside of the waistband fully. Turn the keys to the locked position and retract to lock the belt. To remove locks, insert keys, turn to unlocked position and retract the entire lock mechanism from the belt using the key.
8. (Optional) Thread cable seals through the seal holes and pull tight as shown. Align the seals using the channels built into the belt. Use cable cutters to trim excess cable and crimp on an end cap as shown. Note: Cable seals should always be used in combination with the locks. Using cable seals alone can allow for excessive movement in the locking mechanism, leading to uncomfortable pinching.

Care and Cleaning

While wearing your chastity belt, you can wash it in the bath or shower with whatever soap or cleanser you prefer for use on your own body. We recommend the use of a detachable shower head to make it easier to rinse all areas thoroughly. For best comfort, after washing, dry thoroughly and moisturize with a good quality lotion of your choice.

To clean your chastity belt while not wearing it, you can use any standard soap you'd use to wash your hands or hand wash dishes. Avoid any highly acidic or caustic cleaners as they may damage the polymer parts of the belt. We recommend against boiling your chastity belt, as the polymer parts may warp.